The kit is designed to repair always on airbag light. Suitable for LED airbag lights only up to 2.5W
Timer with accuracy, from 1 to 10 seconds.
- length - 33 mm
- width 28 mm
- height 21 mm
LED indication for operation
Maximum allowable load control 12V/0.2A Suitable for LED Lights only up to 2.5W
Power: red + , black - Have protection against reverse supply voltage.
Positive (red wire) must be connected to contact switch 12V+ , Negative( black wire) to ground.
Output: yellow wire - connected to airbag light positive, negative of the airbag light – to ground
Power supply - 12V DC
Time is adjusted by trimmer PR - 100K – Rotate clockwise – increase the delay time.
Principe of work:
When power is on, the timer is activated (the output receive 12V) and keep that position, until end of set time.
By restart power supply - cycle repeat.
The kit is assembled.
1. LED Timer
2. Instruction for use and wiring diagram.